Verify the input voltage is a steady 12V DC.
Always change the default Master Code immediately after installation to prevent unauthorized access to your programming settings.
Check for a short circuit in the wiring or an "anti-tamper" alarm trigger. V2000-c Rfid Access Control User Manual
Before mounting, ensure the power is disconnected. The rear of the unit features a color-coded wiring harness. Description Positive Power Supply Black Negative Power Supply Blue Normally Open (Electronic Lock) Purple Common Terminal Orange Normally Closed (Magnetic Lock) Yellow Exit Button Input Pink Doorbell Interface 3. Programming Basics
The V2000-C is a single-door multifunction standalone access controller. It supports up to and allows access via RFID card, a 4-to-6 digit PIN, or a combination of both. Operating Voltage: DC 12V ± 10% User Capacity: 2,500 Card Reading Distance: 3–6 cm Active Current: Lock Output Load: Max 3A Operating Temperature: -45°C ~ 60°C 2. Installation and Wiring Verify the input voltage is a steady 12V DC
The system is a popular, standalone security solution designed for small to medium-sized businesses, residential complexes, and secure storage areas. This guide serves as a comprehensive manual to help you install, program, and maintain your device. 1. Introduction & Specifications
If you forget the Master Code or wish to clear all settings: Power off the device. Press and hold the # key while powering the device back on. Before mounting, ensure the power is disconnected
Release the key after two beeps. The Master Code is now reset to . 7. Troubleshooting Card not reading: Ensure the card is 125KHz EM frequency.
V2000-C RFID Access Control User Manual: A Comprehensive Guide
Vui lòng đợi xử lý......