Ts1162 Installation Manual ~upd~ May 2026

This guide outlines the physical installation, wiring, and addressing procedures for the TS1162.

Pull the bottom of the body away from the base and lift it off the top tabs. ts1162 installation manual

Test the keypad by entering a valid user code to arm/disarm the assigned areas. This guide outlines the physical installation, wiring, and

Ensure the mounting surface allows the rear tamper lever to be fully depressed when the unit is secured. Enclosure Removal: Undo the retaining screws at the bottom of the keypad. Ensure the mounting surface allows the rear tamper

Once physically installed and addressed, the keypad must be enabled within the Challenger system programming: Access the (Default code: 4346 ). Navigate to the RAS Configuration menu. Enable the specific RAS address you assigned to the TS1162.

For further technical support or to download the full PDF documentation, visit the Aritech Support Portal or Ness Corporation .

The TS1162 is designed for surface mounting. Its durable plastic housing allows it to be placed up to 1.5 km away from a Challenger panel or Intelligent Access Controller via the RS-485 LAN.