230V/240V AC and often a 12V DC outlet for battery charging Fuel and Oil Requirements Because the

This often indicates a dirty air filter or a partially clogged carburetor jet.

Clean every 50 hours of use. Wash the foam element in warm soapy water, dry it, and apply a small amount of engine oil before reinstalling.

Place the generator on a flat surface in a well-ventilated outdoor area. Never run it indoors or in a garage due to carbon monoxide risks.

Inspect every 100 hours. The gap should be between 0.7mm and 0.8mm . Use a wire brush to remove carbon deposits.

Pull the starter cord slowly until you feel resistance, then pull it briskly to start the engine.