Makerbase Mks Dlc V21 Manual Link | [new]

Excellent for CNC milling and routing. Candle: A clean, simple interface for GRBL-based CNCs. Common GRBL Settings

Ensure you have the CH340 driver installed on your computer.

Since the MKS DLC v2.1 runs GRBL, it is compatible with a wide range of open-source software. Recommended Software The best free option for laser engraving. makerbase mks dlc v21 manual link

Check your Vref on the stepper drivers; they might not be getting enough current.

Check if your $32 setting is correct and ensure the TTL wire is on the correct pin. If you need more specific help, I can guide you through: The exact jumper settings for your specific stepper drivers A step-by-step guide for configuring LaserGRBL How to wire limit switches to prevent crashes Excellent for CNC milling and routing

Once connected via USB (usually at ), you may need to adjust these settings in the console: $100, $101, $102 : Steps per mm for X, Y, and Z. $32=1 : Enable Laser Mode (if using a laser).

Use the TTL/PWM port (usually 3-pin or 2-pin) to control laser intensity. Since the MKS DLC v2

Insert your stepper drivers into the slots for the X, Y, and Z axes.