Gemel Txshs User Manual Site

The TXSHS remote typically features two buttons and a status LED: Used to arm the system. Button 2 (Smooth): Used to disarm the system.

Press both Button 1 and Button 2 simultaneously. Hold them for approximately 10 seconds until the LED on the remote stops flashing.

To activate the anti-theft function, press once. The following sequence occurs: Turn indicators flash twice. An alarm tone sounds twice (if programmed). Gemel Txshs User Manual

Remove the screws on the back of the case and separate the two halves. Carefully remove the old battery.

The turn indicators will flash three times, and the alarm tone will sound three times to confirm the motion sensor is off. The TXSHS remote typically features two buttons and

If you arm the alarm more than one minute after turning off the ignition, you must hold Button 1 for longer than one second. If the bike is left deactivated for over an hour, the system may shut down to save battery; in this case, cycle the ignition to wake it up. Deactivating the Motion Sensor

If the fob lights up but the bike doesn't respond, you may be outside the 30-second window after the ignition is turned off. Try turning the ignition on and then off again. Hold them for approximately 10 seconds until the

If the sync procedure fails, check the battery voltage. Low battery is the most common cause of pairing issues. Gemel TXSHS alarm operating advice needed - UKGSer

If your remote stops responding (often after a battery change or if buttons were pressed over 256 times out of range), use this procedure to re-pair it: