Fanuc Wn57 Override Function Is Active ((link)) May 2026

Find the entry labeled or "倍率" (in some regional settings). Change the status from "YES" (or 1 ) to "NO" (or 0 ). Method 2: Adjusting Keep Relays (K-Addresses)

A technician may have used the override function to bypass a faulty interlock or sensor during a recent repair and forgot to disable it.

Understanding the FANUC WN57 Override Function Is Active Message fanuc wn57 override function is active

If the machine was recently accessed remotely via FANUC LADDER-III software, the override might have been triggered from the external PC. Summary Table: WN57 Message Details Description Message Type PMC Status/Warning (WN) Standard Address Typically controlled by K906.0 Criticality Low (Warning), but unsafe for production Required Action Disable Override Function in PMC Settings

The message is a specific PMC (Programmable Machine Control) warning often encountered on FANUC Series 0i and 30i/31i/32i CNC systems. Unlike critical hardware alarms that halt all operations, WN57 is primarily a status notification informing the operator that a specific debug or maintenance mode has been left enabled. What is the WN57 Override Function? Find the entry labeled or "倍率" (in some

The "Override Function" mentioned in this message refers to a specialized tool used by machine tool builders and maintenance technicians to debug the . When this function is active, it allows for the "forced" manipulation of PMC signals—effectively overriding the standard logic of the machine's ladder to test specific behaviors or troubleshoot faulty sensors.

In rare cases, a loss of CMOS memory or a failing backup battery can cause parameters and keep relays to scramble, potentially "flipping" the bit for the override function. Understanding the FANUC WN57 Override Function Is Active

In many FANUC configurations, this function is tied directly to a system keep relay. The most common address used to control this function is . Go to SYSTEM -> PMC -> PMCPRM -> KEEPRL . Locate K906 and ensure bit 0 is set to 0 .