The scale must be on a hard, flat surface to ensure the sensors activate correctly.
When the display flashes , press the Zero key until it flashes "E" .
Locate the SW1 button (often a small micro-switch) usually found on the bottom of the unit or inside the casing on the left side of the main board. Press it using a small tool like a pen. The display should change to "DIAG" (Diagnose). avery berkel l126 calibration
You will typically need weights equal to one-third, two-thirds, or full capacity (often 5kg, 10kg, or 15kg depending on your specific model).
Use the Zero button to toggle between units (e.g., kilograms or ounces) and select your preference with the Test button. The scale must be on a hard, flat
If your scale is showing a "Zero Capture" error (often indicating the cell is out of its 2% tolerance), you may need to perform a simple reset without a full span calibration: Access the micro-switch on the circuit board.
Turn the scale on and allow it to sit for at least 15 minutes to stabilize the electronics. Step-by-Step Calibration Procedure Press it using a small tool like a pen
Ensure the scale platform is empty and clean. The display will prompt "Load Zero" . Press the Test button to capture the zero point. The scale will scroll for a few seconds as it stabilizes.
The display should read "DONE" or "PASS" once the span is captured.
Press to scroll to "Zero Balance," then press Semi-Auto Tare to capture the current zero without clearing existing span data. Troubleshooting and Maintenance YouTube·Velocity How to restart Avery Berkel scale