What is a decoder, and why do I need it?

A combination of audio decoders and video decoders are required for you to watch live tv and recordings. In simplistic terms, decoders take compressed audio/video frames, and decompresses them into audio samples for sending to the speakers, or video frames for displaying on the screen.

NextPVR is a non-commerical application, and ships without any decoders installed, since these would cost $$$ for me to legally license and distribute. Instead, NextPVR will make use of decoders you already have on your system. Some of these are supplied with Windows, some come from other applications you have installed, some are downloaded from Internet sources.

Below is info on what decoders you need and recommendations, the TL;DR answer: install the LAV decoders from HERE, then go to the Settings->Decoders screen, and set everything to the LAV decoders

Which decoders do I need?

It depends on the country you're in, the television system you're using, and sometimes the device you use. If you don't have a decoder you require, NextPVR will tell you what type of decoder it's missing. Here are some example decoder requirements for common user groups:

USA/Canada: Usually require MPEG-2 video decoder, MPEG1 audio and AC3 audio decoders
Freeview UK: Requires most decoders. MPEG-2 and H.264 video decoders, and MPEG1 audio, AC3 audio and HE-AAC decoders
Freeview NZ (DVB-S): Requires MPEG-2 video, MPEG1 audio decoder
Freeview NZ (DVB-T): Requires H.264 video, HE-AAC audio decoder
HDPVR/HDPVR2/Colossus/Rocket: Requires H.264 video decoder, AAC audio decoder

3040 Cnc Usb Setup -

You must copy a specific DLL file (often named NcUsbPod.dll or rnrmotion.dll ) provided with your machine into the Mach3/PlugIns folder.

Mach3 is the most popular CNC control software for low-end machines.

) converts USB signals into step and direction pulses for the motors. 3040 cnc usb setup

Some 3040 models come with their own CNC USB controller software . What are the 7 major parts of a CNC machine? - HIRUNG

While optional, adding X, Y, and Z limit switches is highly recommended for protecting your machine and establishing a consistent home position. Software Setup and Installation You must copy a specific DLL file (often named NcUsbPod

To prevent disconnects during long jobs, use a shielded USB cable with a magnetic ferrite ring.

After launching Mach3, restart the software and select your USB motion card from the configuration menu. 2. Using Proprietary CNC USB Controller Software Some 3040 models come with their own CNC

The software setup varies depending on whether you are using the manufacturer's proprietary software or a third-party controller like Mach3.

Is there anything else I should be aware of?

NextPVR is a 32bit application so will only see 32bit decoders on the machine. It can't see 64bit decoders, so these will not be listed.

NextPVR's decoder settings only apply to Live TV, and the playback of .ts recordings. For playback of other file types, like .mkv/.mp4/.avi, it's left to Windows to decide what decoders etc are used during playback. Installing LAV from HERE will often resolve issues with playback of these other file types.